

	[ Home ] [ Up ]

WWII US HELMET DECALS

U.S. Army Infantry division and rank decals for the U.S. M1 Steel Pot Helmet used during WWII and extending through the Korean War, Viet Nam and into the 1980's. The M1 helmet was eventually replaced by a new helmet made of space age materials and of a new design.

These are wet transfer decals and at the bottom of this page you will find application instructions for applying the decals.


1st Infantry Division	$3.50

2nd Infantry Division	$3.50

3rd Infantry Division	$3.50

4th Infantry Division	$3.50

29th Infantry Division	$3.50

36th Infantry (Texas Division)	$3.50

2nd Ranger Diamond	$3.50

501st PIR	$3.50

502 PIR	$3.50

506th PIR	$3.50

327th Glider Infantry	$3.50

509th PIR	$3.50

Red Devils	$3.50

Captain Helmet Rank Decal	$2.50

Lt. Helmet Rank Decal	$2.50

Major Helmet Rank Decal	$2.50

Colonel Helmet Rank Decal	$2.50

Medic Helmet Cross Decal	$3.50

MP Helmet Decal	$3.50

Helmet Decals

Application Instructions

Before application make sure surface where decal is to be applied is clean and free of dirt.

1) Trim decal with sharp scissors or a razor knife.

2) Place decal in warm (not hot) water for 15 to 20 seconds

3) Place decal next to place of desired application and gently slide off backing paper into position

4) Try not to rub the decal any more than necessary because this can tear the decal.

5) Once in place and when decal is completely dry you will achieve best results if you apply a coat of clear topcoat such as Testors clear topcoat. (Do not use Krylon clear coat or polyurethane because they attack the ink in the decal)

Remember to visit www.packrat-toyz.com